of the head. Then cut the front part of the hair to-
wards the middle of the head.
5. Hold the hair trimmer
1
so that the comb attach-
ment is flat on the head. Then run it evenly through
your hair.
6. If possible, trim the hair against the direction of growth.
7. To ensure that you trim all hairs, run the hair trimmer
over the same area of hair several times.
8. If the comb attachment is not mounted, use the hair
trimmer only with the hair trimmer attachment for a
very short cut.
9. Comb your hair thoroughly again and again.
Beard trimmer attachment
You can mount the comb attachment for the beard trimmer
attachment
10
on the beard trimmer attachment
16
.
You can choose from 4 different cutting lengths with the
comb attachment for the beard trimmer attachment.
The numbers 3, 4, 5, 6 correspond to the cut lengths in
mm with the fine setting level 1 (sliding switch for fine
adjustment
4
at the very bottom). With the fine set-
ting level 3 (sliding switch for fine adjustment at the very
top), the configured cut length is reduced by approx.
0.5 mm depending on the trimming angle.
1. Comb the beard in the direction of growth.
2. Cut the beard downwards from the ear to the chin.
First trim one and then the other side.
Choosing the correct attachment
GB IRE
AFTER SALES SUPPORT
www.aquarius-service.com
23
00800 - 36 46 36 00
GB
IRE