Operation
14
Laminating
1. Move the ON / OFF switch
3
to “
ON” (―) (see fig. B).
The ready indicator will turn from black to red within the next
1 ½–2 minutes.
2. Once the ready indicator
1
is red, place the document between the two
sides of the laminating pouch
6
.
Make sure that the document is flush with and aligned as close as possible
to the sealed edge of the laminating pouch.
3. Insert the laminating pouch so that it is centered and with the closed-edge
first into the laminating pouch infeed slot
2
on the back of the laminator.
The heating rollers will automatically pull the laminating pouch in and move
it to the laminating pouch output slot
5
on the front of the laminator.
Don’t use force to pull out the laminating pouch.
4. Remove the laminating pouch and let it cool off briefly on a flat surface.
− If necessary, you can cut off excessive material after it has
cooled off.
− Repeat the process if the laminating pouch has not
adequately adhered to the document.
5. Move the ON / OFF switch to “
OFF” ( ) to switch the laminator off.
Removing a jammed laminating pouch
The laminator is equipped with an antiblocking system. If the laminating pouch
was not inserted straight or it becomes jammed in the laminator, proceed as
follows:
1. Move the ABS switch
4
towards the laminating pouch infeed slot
2
and
hold it down (see
fig. B).
2. Pull the laminating pouch
6
out of the laminator.
It is recommended you pull the laminating pouch out in the
direction of its larger end.
You can place the document in a new laminating pouch and laminate it again.
