Cleaning
14
The heating rollers will automatically pull the laminating pouch in and move it
to the laminating pouch output slot
5
on the front of the laminator. Do not use
force to pull out the laminating pouch.
4. Remove the laminating pouch and let it cool off briefly on a flat surface.
− If necessary, you can cut off excessive material after it has cooled
off.
− Repeat the process if the laminating pouch has not adequately
adhered to the document.
5. Move the ON / OFF switch to “
OFF
” ( ) to switch the laminator off.
Removing a jammed laminating pouch
The laminator is equipped with an antiblocking system. If the laminating pouch was
not inserted straight or it becomes jammed in the laminator, proceed as follows:
1. Move the ABS switch
4
towards the laminating pouch infeed slot
2
and hold
it down (see
Fig. B
).
2. Pull the laminating pouch
6
out of the laminator.
It is recommended you pull the laminating pouch out in the direction
of its larger end.
You can place the document in a new laminating pouch and laminate it again.
Cleaning
WARNING!
Burn hazard!
The laminator will become hot during operation. You may burn
yourself.
− Always let the laminator cool off completely before you clean it.
NOTICE!
Risk of short circuit!
Water or other liquids that have penetrated the housing may cause
a short circuit.
− Never submerge the laminator in water or other liquids.
