19
AUS
Attachment and operating
•
Wear safety gloves.
•
Avoid contact with skin and eyes.
•
Make sure you observe the “Safety Instructions” paragraph.
•
Only ever refuel the tool outdoors or in sufficiently ventilated rooms.
•
Clean around the filling area. Contaminants in the tank will cause operating prob-
lems.
•
Before refuelling, shake the container with the fuel mixture.
•
Carefully pour in the fuel mixture to the lower edge of the filler.
•
Close the fuel filler cap. Ensure the fuel filler cap closes tightly.
•
Clean the fuel filler cap and the area around it.
•
Check the tank and the fuel line for leaks.
•
Before starting the motor, remove yourself from the fuelling place by at least three
metres.
Draining fuel.
Only ever empty the tank outdoors or in well-ventilated rooms. Make sure not to spill fuel
or chain oil into the soil (environmental protection). Use a proper base.
•
Hold a collection container beneath the fuel drain bolt.
•
Unscrew the tank cap and remove it.
•
Allow the fuel to run out completely.
•
Screw the tank cap on firmly by hand.
Check before use!
Check the safe condition of the device:
•
Check the device for leaks.
•
Check the device for visual defects.
•
Check that all parts of the device have been securely fitted.
•
Check that all safety devices are in proper condition.
Starting the blower vac
•
To start the blower vac ensure that the intermediate suction/blower tube is fitted
correctly.
•
To use the appliance follow the motor starting instructions as described in the op-
erating instructions.
•
Make sure that nothing is covering the exhaust pipe as this would cause heat to
build up.
•
Hold the handle firmly with your right hand and swing the nozzle back and forth so
that the desired area is cleared of contamination.
•
The throttle control (3) and the engine switch (1) are integrated in the handle.
•
With the throttle lockout (2), the engine can be locked at full throttle without con-
stantly pressing the throttle control (3). Caution: Before switching off the device,
push the throttle lockout (2) to idle.
