18
NOTE!
Product damage!
Usage of incorrectly stored or undrained fuel mixtures can clog the carburettor or im-
pair engine operation.
-
Put unused fuel in an airtight vessel and store it in a dark, cool room.
-
Use only designated and approved vessels for the transport and storage of fuel.
Recommended fuels:
• Mix the fuel mixture as per the fuel mixing table.
• Put the correct amount of fuel and 2-stroke oil into the enclosed mixing bottle. Then
shake the vessel well.
Fuel mixing table
Mixing procedure: 40 parts fuel to 1 part oil
Example:
1 L fuel : 0.025 L 2-stroke oil
5 L fuel : 0.125 L 2-stroke oil
XIII. Assembly and operation
Assembly
When assembling this machine, please follow the specified assembly instructions.
Fitting the handle to the machine, fig. 3 - 4
1. Attach the guide handle (5) in the middle of the shaft.
2. Use the allen screws (5.1) and the nuts (5.2) to mount the handle to the shaft.
Fitting the shaft to the engine unit, fig. 5 - 6
1. Remove the protective caps at the ends of the respective shafts.
2. Slide the bottom shaft (b) into the top shaft of the engine unit until the locking pin
(a) engages in the hole (c). The assembly will be easier if you rotate the bottom shaft
(b) slightly in both directions.
3. Then tighten the rotary knob (d) firmly.
Fitting the protective device, fig. 7 - 7.1
1. Align the hole in the protective device (3) with the cutting unit.
2. Tighten the screw for protective device (3.1) and the wing nut.
Fitting the thread coil, fig. 19
1. Insert the allen key (18) into the hole provided on the cutting unit to fix it in place.
2. Turn the thread coil (2) clockwise until the thread coil is securely mounted.
AUS
Before commissioning/Assembly and operation
