12
AFTER SALES SUPPORT
www.aquarius-service.com
00800-36 46 36 00
MODEL: 9163901 PRODUCT CODE: 91500 08/2014
Hotline free
AFTER SALES SUPPORT
13
00800-36 46 36 00
www.aquarius-service.com
Hotline free
MODEL: 9163901 PRODUCT CODE: 91500 08/2014
3. Start by cutting the hair in the neck or on the sides and cut towards
the centre of the head. Then, cut the front section of the hair to-
wards the centre of the head.
4. Hold the device so that the comb attachment rests flat on the head
(for attachments 6, 9 and 12 mm this side is round). Move the device
evenly through the hair.
5. If possible, cut against direction of hair growth.
6. In order to catch all the hair, move the device several times through
the same section of the hair.
7. Use the device only with the cutting attachment and without comb
attachment to cut hair very short.
8. Comb the hair repeatedly and well.
Beard trimmer attachment
1. Comb the beard in the direction of growth.
2. Cut the beard from the ear to the chin down-
ward. First trim the one and then the other side.
3. Use the beard trimmer attachment without comb attachment to cut your
beard very short or to cut moustache and contours. The cutting edge
of the beard trimmer attachment is set at right angles to the beard.
NOTE:
The comb attachment is used to change the cutting
length in 4 steps. The numbers 3, 4, 5, 6 correspond
to cutting lengths in mm when using the fine ad-
justment level 1 (slider switch at the very bottom).
When using fine adjustment level 3 (slider switch
at the very top), the set cutting length is reduced by
1 mm each.
Pushing on/replacing cutting attachments 1, 2, 4, 6 and 7
(
→
01. Product Overview)
WARNING!
Risk of injury from cutting
Switch off the device before replacing or changing the
attachments.
1. Remove/replace an attachment by
pressing it with the thumb towards the
back (see figure).
2. Push on the attachments by inserting the
bottom bracket of the attachment into the
rail of the device and press the upper part
of the attachment onto the device until it
audibly and firmly locks into place.
Pushing on/replacing comb attachments 8 and 9
(
→
01. Product Overview)
1. To push on the comb attachments (
8
) push the corresponding
attachment carefully over the hair trimmer attachment, then press
the lower part of the comb attachment firmly until it locks into place.
2. To push on the comb attachment (
9
) for the beard trimmer attach-
ment push the comb attachment carefully over the beard trimmer
attachment until it firmly locks into place.
3. To remove/replace the comb attachments release the comb attach-
ment at its bottom end and pull it off the device.
Hair trimmer attachment
1. Comb the hair well.
2. Place a sheet or cape around throat and neck to
prevent cut-off hair from dropping into the collar.
