September 12, 2005 • Alcorn McBride AmpTraXX User’s Manual • Rev 1.2
Page 16
Update AmpTraXX Firmware
This button will only be visible if you are in connected to AmpTraXX and DIP switch #3 is in the Update
Firmware position. Clicking this button will allow you to select a valid HEX firmware file to update your
AmpTraXX firmware. For more details on this process, see the
Updating Your Firmware
section located in
this manual.
Front Panel Status Indicator
When in
Live Mode
, this indicator will tell you whether AmpTraXX’s front panel volume controls are enabled.
When they are enabled, the AmpTraXX application will lock out the on-screen gain controls. Instead, these
controls will reflect the current gain value based on the front panel values.
Gain Control
You can adjust the gain of each channel by using the Gain Control slider. Gain is adjustable from a value of 0
(muted ) to 10. The readout below indicates the actual value of the gain setting.
Filter Type
Each AmpTraXX channel can be set up with a variety of filter types. You can insert a
Band-pass
,
Notch
,
High-pass
, or
Low-pass
filter. This section also contains a button to enable a
1Khz
test tone to aid in channel
identification and output testing. Of course, you can always select the
Flat
filter, which passes the input signal
with no frequency alterations.
