system you can turn the vacuum system clockwise to shut it off. The tool will
still be able to set rivets, but it must be tilted backwards to allow spent mandrel
to fall into nail container.
ADDITION OF HYDRAULIC FLUID
Tool is shipped with oil. If it becomes necessary to add oil, follow this procedure.
Please use the supplied priming pump as shown (fig. 4)
1
．
Disconnect air supply to tool and
switch ON/OFF valve to OFF position.
2
．
Remove seal screw and seal (see Fig. 3)
3. Screw the priming pump of filled oil into the
bleed screw hole. Actuate the priming pump by
pressing down and releasing several times until
resistance is felt. (Fig. 4)
4. Remove the priming pump and the excessive oil
will flow out. Wipe away and clean out the
excessive oil and replace the seal and screw.
IMPORTANT: Use only Anti-Foam Hydraulic Fluid
WARNING: ALWAYS WEAR SAFETY GLASSES
WHEN OPERATING AND PERFORMING MAINTENANCE ON TOOL
