alcatraz ROCK-1, Инструкция по установке

Страница: 2 / 5

Panel +12v * RED
Panel GND * BLACK
Panel D0 / RS485A * GREEN
Panel D1 / RS485B * WHITE
Panel Beeper YELLOW
Panel Tamper VIOLET
Panel Hold BLUE
Panel LED Green * ORANGE
Panel LED Red BROWN
Badge Reader +12v * RED
Badge Reader GND * BLACK
Badge Reader D0 / RS485A * GREEN
Badge Reader D1 / RS485B * WHITE
Badge Reader Beeper YELLOW
Badge Reader Tamper VIOLET
Badge Reader Hold BLUE
Badge Reader LED Green ORANGE
Badge Reader LED Red BROWN
Wiring Table
Mount 2-gang switch box in wall
Installation to be performed only by certified installer
Power Requirement: PoE+ (802.3at Type 2) 30W
Unit to be powered by UL294B certified IEEE PoE+ 802.3at Type 2
Power Sourcing Equipment using shielded cat5e or higher cable
Wiegand Maximum Cable Length: 500 ft - 22 AWG (152 m), 300 ft - 24
AWG (91 m)
Complies with US FDA performance standards for laser products except for
deviations pursuant to Laser Notice No. 50, dated June 24, 2007
CAUTION: Use of controls or adjustments or performance of procedures other
than those specified herein may result in hazardous radiation exposure
Step 1 – Installation Prerequisite
Parts Included
1x Alcatraz Rock
1x Wall Mount
1x Wiring Harness
1x Wall release tool
4x Cable Ties
4x Mounting Screws #6-32
Required tools and supplies
2-Gang switch box
Gel filled B connectors or equivalent
22/6 cable, 5-9 conductor, Genesis 12061109 or equivalent (Wiegand)
4 conductor shielded twisted pair, Belden 3107A or equivalent (OSDP)
Level
Measuring tape
Wire stripper / cutter
Phillips screwdriver
Panel Cable Badge Reader Cable
Install on door opening side
* Required for operation
5ft (1.5m) from floor
1/2” (13mm) minimum
Screw tabs must be in
vertical position
Badge reader
mounted at
standard height
Position close to door
Leave minimum of 1/2”
between 2-gang switch
box and door frame
2-gang
switch box