Setting Ethernet Port Parameters
Configuring Ethernet Ports
page 1-14
OmniSwitch 6624/6648 Network Configuration Guide
April 2004
Note.
Since the
interfaces ifg
command is only supported on Gigabit interfaces only the
gigaethernet
keyword should be used.
Resetting Statistics Counters
The
interfaces no l2 statistics
command is used to reset all Layer 2 statistics counters on a specific port, a
range of ports, or all ports on a switch (slot).
To reset Layer 2 statistics on an entire slot enter
interfaces
followed by the slot number and
no l2
statistics
. For example, to reset all Layer 2 statistics counters on slot 2 enter:
-> interfaces 2 no l2 statistics
To reset Layer 2 statistics on a single port enter
interfaces
followed by the slot number, a slash (
/
), the
port number, and
no l2 statistics
. For example, to reset all Layer 2 statistics counters on port 3 on slot 2
enter:
-> interfaces 2/3 no l2 statistics
To reset Layer 2 statistics on a range of ports enter
interfaces
followed by the slot number, a slash (
/
), the
first port number, a hyphen (
-
), the last port number, and
no l2 statistics
. For example, to reset all Layer 2
statistics counters on ports 1 through 3 on slot 2 enter:
-> interfaces 2/1-3 no l2 statistics
As an option, you can document the interface type by entering
ethernet
,
fastethernet
, or
gigaethernet
before the slot number. For example, to reset all Layer 2 statistics counters on port 3 on slot 2 and docu-
ment the port as Fast Ethernet:
-> interfaces fastethernet 2/3 no l2 statistics
Note.
The
show interfaces
,
show interfaces accounting
, and
show interfaces counters
commands can
be used to display Layer 2 statistics (e.g., input and output errors, deferred frames received, unicast pack-
ets transmitted). For information on using these commands, see the
OmniSwitch CLI Reference Guide.
Configuring Flood Rates
The following subsections describe how to enable the maximum flood rate (see
“Enabling the Maximum
Flood Rate” on page 1-14
), enable the maximum flood rate for multicast traffic (see
“Enabling Maximum
Flood Rate for Multicast Traffic” on page 1-15
), and how to configure the flood rate on an entire switch
(slot), a specific port, or a range of ports (see
“Configuring Flood Rate Values” on page 1-15
).
Enabling the Maximum Flood Rate
The
interfaces flood
command can be used to enable the maximum flood rate for a switch (slot). Note that
only one slot can be configured at a time. You cannot configure specific ports or ranges of ports.
Note.
To enable flood multicasting on an interface, see
“Enabling Maximum Flood Rate for Multicast
Traffic” on page 1-15
.
Содержание OmniSwitch 6624
