Alcatel OmniAccess 4308, Руководство по установке

Страница: 34 / 44

OmniAccess 4308: Installation Guide
20 Part 031638-00 May 2005
Access Point Status LEDs
Each LED represents the status of APs connected to a specific port on the
switch. During operation, the LEDs provide the following information:
The LED states in Table B-3 are listed in order of precedence (highest to
lowest). If more than one AP is connected to the port, the state with the
highest precedence is displayed.
Pin Outs
The RJ-45 female connector pin-outs are shown in Figure B-2 :
F
IGURE
B-2 FE Network Port Pin-outs
T
ABLE
B-3 AP Status LED
Status Description
Red (solid) An AP on this port has failed (highest precedence).
Red (flashing) An air monitor on this port has detected an unsecured AP.
The AP is attached to your network but is not listed in the
switch security policies. If security policies are enabled,
clients are not granted access to your network through the
unsecured AP.
Green
(flashing) An air monitor on this port has detected interference. The
interfering device (AP or other radio source) has been
detected by your valid APs, but has no wired presence on
your network.
Amber (solid) Load balancing is enabled on this port or an AP has reached
the maximum number of clients it is configured to support.
Green (solid) All detected APs on this port are operating as expected.
Off No AP is detected on the port (lowest precedence).
2
LNK/
ACT
POE
1
2
3
4
5
6
7
8
RJ-45 Female
Pin-Out
**Serial optional
*POE optional
Direction
Input
Output
10/100 Mbps
Ethernet
Serial TxD ** (POE positive*)
Serial TGND ** (POE positive*)
Serial RxD ** (POE negative*)
Serial RGND ** (POE negative*)
1
2
3
4
5
6
7
8 ETH Rx+ (POE negative*)
ETH Rx– (POE negative*)
ETH Tx+ (POE positive*)
ETH Tx– (POE positive*)