Alcatel-Lucent Service Aggregation Router 7705, Руководство по установке

Страница: 16 / 20

Installing Adapter Cards
Page 16 7705 SAR T1/E1 ASAP Adapter Card Installation Guide
Provisioning an Adapter Card
After the IOM has been activated on the CSM (Steps 1 and 2 below), continue in the
config
context with the following CLI commands to provision the adapter card. The steps
below provision a 16-port T1/E1 ASAP Adapter card version 1 in MDA slot 5 and a
32-port T1/E1 ASAP Adapter card in MDA slot 6.
The 7705 SAR-8 supports up to 6 adapter cards and the 7705 SAR-18 supports up to
12 adapter cards in any combination that does not exceed the maximum; however, for a
network application, at least one of the installed cards must be a network-capable adapter
card. Within this maximum, up to 6 16-port T1/E1 ASAP Adapter cards and/or 32-port
T1/E1 ASAP Adapter cards can be configured on a 7705 SAR-8, and up to 12 16-port T1/E1
ASAP Adapter cards and/or 32-port T1/E1 ASAP Adapter cards can be configured on a
7705 SAR-18.
Command Syntax Example
Step 1. card slot-number card 1
Step 2. card-type card-type card-type iom-sar
Note: The slot-number is always 1 and the card-type is always
iom-sar
.
Step 3. mda mda-number mda 5
Step 4. mda-type mda-type mda-type a16-chds1
Step 5. exit exit
Step 6. mda mda-number mda 6
Step 7. mda-type mda-type mda-type a32-chds1v2
Step 8. exit exit
You can now install the adapter cards; see Installing an Adapter Card . If you need to install
an additional adapter card, repeat the configuration process from Step 6 before installing the
card.