nection and the card standoff posts to the chassis.
Fig. 11:
Location of the lateral connector for SLOT 1 expansion module
(6)
Using a screwdriver, remove the cover covering the expansion slot. This cover is located on the front panel.
Fig. 12:
Remove the cover from SLOT 1
(7)
Insert the expansion board and connect it. This operation must be carried out carefully, without forcing any
piece or part of the device.
(8)
Screw in the board. Firmly tighten the screws without damaging the board.
(9)
Put the cover back on the expansion slot and screw it down.
Fig. 13:
Replace the cover on SLOT 1
(10) Reposition the top panel flap and screw it into place using the screws.
Fig. 14:
Replace the screws on the top panel flap
(11) Connect and switch on the device, as explained in section
Connecting
on page 17. Should you encounter any
problems, switch off the device and make sure that the above steps have been carried out correctly. If the prob-
lem persists, please contact your supplier.
(12) Connect a terminal to the console and check that the device detects the expansion board.
**************************************************
**************************************************
**************************************************
BIOS CODE DUMP....................
BIOS DATA DUMP.....
End of BIOS dump
FLASH BIOS CODE VERSION: 02.01
Mar
6 2013 17:59:56
L1
Alcatel-Lucent
3 Components and Power Supply
OA58XX-NW Router
9
