Note
Some devices leave the factory with customized settings. This personalization can mean that the de-
fault configuration is different from the one shown above.
This initial configuration allows you to access the device configuration console through the Telnet IP protocol. To do
this, you need to carry out the following steps:
• Configure the IP terminal (normally a PC) Ethernet interface with an IP address within the range [192.168.1.2,
192.168.1.254] and with mask 255.255.255.0. E.g. 192.168.1.2, 255.255.255.0.
• Connect the IP terminal Ethernet interface to any of the OA5725R router’s two first Ethernet Switch ports (LAN1..2)
through an Ethernet cable (RJ45).
• Initiate a Telnet session from the IP terminal to IP address 192.168.1.1 ( OA5725R default address).
• The default configuration does not ask for credentials (user/password) to access the console.
A.4 Connectors
A.4.1 LAN Connector
RJ45 LAN
RJ45 PIN
LAN
1
2
3
4
5
6
7
8
Tx+(input)
Tx-(input))
Rx+(output)
--
--
Rx-(output)
--
--
A.4.2 DSL Connector
RJ11 DSL
RJ11 PIN
DSL
1
2
3
4
--
Line
Line
--
Note
With each DSL daughter board, ALU provides one RJ11 cable with the following internal reference:
CRJ11AWG26_UL and internal code: 22253.
Technical Information
Alcatel-Lucent Enterprise
28
OA5725R Router