All Rights Reserved © Alcatel-Lucent 2009
Page 15
2/5 network setup
Phase 2 is running: the set is looking for IP
addresses
3/5 config download
Phase 3 is running: the set is trying to get a
lanpbx file
4/5 binary download
Phase 4 is running: the set is downloading a new
binary
5/5 connecting
Phase 5 is running: the set is trying to set up the
signaling link with the system
802.1x Auth Failed
802.1x authentication has failed: RADIUS server
is unreachable, access is refused to the terminal
on the RADIUS server or the terminal has an
incorrect identity (bad login and/or password).
802.1x Auth Success
802.1x authentication process is complete. The
RADIUS server grants access to the terminal, the
authenticator opens its port.
3.3.
Ethernet Link
By default, IP Touch sets are configured to perform auto-negotiation on both ports (LAN and PC).
Provided that the PC and the LAN switch are also configured to perform auto-negotiation, this is
the best configuration for QoS improvement.
However, depending on the network configuration, it may not always be possible to leave the
terminal in auto-negotiation: link speed and duplex of both ports can be forced to determined
values using the supervisor menu:
– Plug in the set, as described: module IP Touch 4008 EE/4018 EE Phone - Commissioning §
Commissioning the 4008 EE or 4018 EE IP Touch Set.
– Once the set displays initialization, press i, then # or enter the admin settings during phone
idle status.
– Use the navigation key to select Ethernet Links
– Modify data as requested
A configuration mismatch between the terminal and PC/LAN switch can lead to nasty effects on
the voice quality:
– No link (or speed mismatch): 8, 9, 11 and 12
– Packet loss (or duplex mismatch): 2, 4, 7 and 14
