QUICK PROGRAMMING GUIDE 912-DM A/V TO DVB-C
ENG
Set the programming switch of the 912-DM module to the OFF position. The programming
indicator light will now go out.
Service
Active
On
Select On/Off to enable or disable the corresponding
service. Then press T to transmit.
OK+
+OK+T
Service ID
1
You can use the numeric keypad to enter a number of
up to 5 digits as the service identifi er. Then press T to
transmit.
T
Service name
ALCAD S1
Using the keypad, enter the name of the service you want
to modulate. Then press T to transmit.
T
Audio and video codifi cation menu. It is recommended
that you use the default values.
Advanced menu
Advanced
Select the video standard of the input signal. By default
it is set to Auto.
OK+
+OK+T
Use the
keys to adjust the brightness of the input
signal. Then press T to transmit.
+ T
Use the
keys to adjust the contrast of the input signal.
Then press T to transmit.
+ T
Use the
keys to adjust the saturation of the input
signal. Then press T to transmit.
+ T
OK+
+OK+T
TS ID
1
You can use the numeric keypad to enter a number of up
to 5 digits as the TS identifi er. Then press T to transmit.
T
The total BW shows the bandwidth taken up by the sum
of the two modulated services.
The status of the NIT table is shown in grey if no relevant
information is available; in green if the NIT table is
correct; and in red if the NIT table contained in the
module is incorrect.
Orig net ID
1
Network ID
1
BW total
81%
Input
Brightness
Screen format
4:3
Audio mode
Mono
Contrast
Saturation
Audio level
OK+
+OK+T
+ T
Use the
keys to adjust the audio level of the input
signal. Then press T to transmit.
Select the aspect ratio of the input signal, 4:3 or 16:9.
Then press T to transmit.
Select the audio mode, mono or stereo. Then press T to
transmit.
NTSC
Standard video
Auto
Auto
PAL
SECAM
NIT table
No information
Valid
Invalid
Not generated
