ALBERTI FKC 65 UB, Инструкция по эксплуатации

Страница: 21 / 56

Manuale istruzioni
-FKC 65 UB
01/01/19 Rev: 1.0.0
21
8.
INTENDED USE OF THE MACHINE (machine being moved
without washing or drying)
FKC 65 UB
can be handled without brush plate lowered and brushes in contact with
the floor, or with the drying turbine turned off. This can happen during transfer from one
room to another, at the end of the cleaning or for other reasons. It is just required to set
the appropriate controls to raise the brush plate and drive the machine with brake and
accelerator. At this stage the maximum speed adjustment system is not activated, but the
speed is controlled exclusively via the accelerator pedal.
When moving the machine when the operator is not on board, needing to push or pull the
washer-dryer, with traction motor then turned off, it is needed to turn the red lever on the
axle of the rear gear reducer by pulling it towards the rear of the machine.
Thus the gears of the motor reducers are at idle and the machine can be moved easily.
Remember to rotate the red lever toward the front of the machine if you want to activate
the motor-reducer and then again activate the drive system of the machine.
.
9.
REASONABLY FORESEEABLE INCORRECT USE OF THE
MACHINE
WARNING
The machine is not intended for outdoors use.
Do not wash and extract corrosive, flammable, explosive liquids, even if diluted.
It is strictly forbidden to use the machine in environments with explosion hazard where
there are flammable and explosive gases, vapours, liquids and powders.
FOR SAFETY
Do not wash the floors with water hotter than 50°C;
Do not use diesel fuel/benzene or corrosive detergents for washing floors;
WARNING