Alberici Timebox S, Руководство оператора

Страница: 6 / 12

6
Connections to start the equipment by relay transmission of power supply:
Connect one end from power supply straight to the actuator i.e electrical motor, solenoid, a.s.o.). Connect the other one
to pin 1 (COM 1) of J2 connector.
If operation mode is “normally open”, take a wire to the actuator from pin 2 (N.O. 1). These wires must be able to
sustain 10 Amps current draw.
If operation mode must be “normally closed”, take a wire to the actuator from pin 3 (N.C. 1).
Connections to start the equipment by one clean relay switch:
Take a wire to the actuator from pin 1 (COM 1) of the J2 connector.
If operation mode is “normally open”, take another wire to the actuator from pin 2 (N.O. 1).
If operation mode must be “normally closed”, take such wire from pin 3 (N.C. 1).
To/from pulse
coin validator
signal on PIN10
OUT 1: LINE A, N.O.
IN 1: C1 LINE A
OUT 2: LINE B, N.O.
IN 2: C2 LINE B
DISABLE: Vac L or Vcc +
DISABLE: Vac N or Vcc -
POWER IN: GND (ac)
POWER IN: 230Vac,
or
24Vac,
or
+24Vdc,
or
+12Vdc
POWER IN: N (ac)
or
- (dc)
OUT 2: LINE B, N.C.
OUT 1: LINE A, N.C.
POWER TO
EQUIPMENT:
230Vac, or 24Vac, or
+24Vdc, or +12Vdc
To/from pulse
coin validator:
signal on PIN10
OUT 1: LINE A, N.O.
IN 1: C1 LINE A
OUT 2: LINE B, N.O.
IN 2: C2 LINE B
POWER IN: GND (ac)
POWER IN: 230Vac,
or
24Vac,
or
+24Vdc,
or
+12Vdc
POWER IN: N (ac)
or
- (dc)
OUT 2: LINE B, N.C.
OUT 1: LINE A, N.C. EQUIP
MENT
INH –
INH +
N.C. 2
N.O. 2
COM 2
N.C. 1
N.O. 1
COM 1
INH –
INH +
N.C. 2
N.O. 2
COM 2
N.C. 1
N.O. 1
COM 1
+ / L
- / N
GND
+ / L
- / N
GND
DISABLE: Vac L or Vcc +
DISABLE: Vac N or Vcc -
EQUIPMENT