22
...COIN ACCEPTOR…
.. DISCONNECTED ...
PTOR ................... NOT
CTED ................. IN ER
TOR…
…. HOPPE
ROR ….
… CONN
R N° 1…
…. HOPPE
TED ….
… EMPT
8.
Messages
Display contrast
Should the contrast between the characters and the background be not convenient, adjust it as follows:
a.
disconnect the cable from socket POWER IN/CCT of the pcb, and power up the machine;
b.
hold down the “+” and “-“ buttons of the pcb at the same time, and plug the cable into socket
POWER IN/CCT; when the display starts flashing, release both buttons;
c.
a prompt (in Italian language) will propose you to set the desired contrast level;
d.
press the “+” button to increase the intensity of contrast/brightness. Intensity can be adjusted
between -15 and + 15. Standard values range between -1 and +5
e.
once the desired degree of illumination has been reached, press the “ok” button;
f.
power off the machine, then power it on again.
8.1
Messages from the display
8.1.1
Faulty operation:
The following warning:
is accompanied by the system check. For instance, the following sliding warnings:
stand for:
the coin acceptor is not connected,
there is a fault in the note validator,
hopper 1 is properly working
The following error messages can possibly appear:
the mentioned peripheral unit (coin acceptor, or note validator,
or Hopper, a.s.o.) is connected and functioning
the mentioned peripheral unit has been disconnected
the mentioned peripheral unit is connected but faulty
the Hopper is empty
The message
the inserted note is not enabled
means that coins have run out during the payout.
Switch power off, fill it up, and switch power on again:
the board will prompt the hopper to complete the payout.
(
PERIPH
.
UNIT
)
IN ERROR
H
OPPER
EMPTY
Remaining Credit
1 €
BANKNOTE
DISABLED
(
PERIPH
.
UNIT
)
DISCONNECTED
(
PERIPH
.
UNIT
)
CONNECTED
CHANGEONE
OUT OF SERVICE
