Instructions for installation and operation - English
Installation & Use Pares - Marami - Code 10013216 - Edition 2 - 10/2011 – Page
7
Commissioning of SpaPack (Marami with SpaPack only)
2.1
Safety Warning for sand filter
WARNING
: Never start up the system without water.
WARNING:
Whenever you operate the filter or the selector valve, switch off the pump first.
WARNING:
Never allow children or adults to sit on the system.
WARNING:
Do not connect the filter directly to the water network, as the pressure of the water may be too high and exceed
the maximum work pressure allowed by the filter.
WARNING:
Do not clean the lid with solvents, as it may damage its properties (finish, transparency…).
WARNING:
As all the connections are made with joints, it is not necessary to tighten the nuts excessively in order to avoid
that some plastics pieces could break.
2.2
Safety Warning for prefilter pump ter
WARNING:
This pump is specially designed for the prefiltering and recirculation water in spa.
WARNING:
It is designed to work with clean water at a temperature of not over 40°C.
WARNING:
The installation must be carried out by qualified personnel and according to the local safety regulations for spa,
especially with regard to electric regulations and to the specific instructions for each facility.
WARNING:
The rules in force on accident prevention should be carefully followed.
WARNING:
Any modification of the pump requires the prior consent of the manufacturer. Original replacement
manufacturer of the pump assumes no liability for the damage and injuries caused by unauthorized replacement parts and
accessories.
WARNING:
During operation, some parts of the machine are subject to dangerous electric voltages. Work may only
performed on each machine or on the equipment connected to it after disconnecting them from the main and after
disconnecting the starting devices.
WARNING:
The user should make sure that assembly and maintenance tasks are carried out by qualified authorized persons
and that these persons have first carefully read the installation and service instructions.
WARNING:
The operating safety of the machine is only guaranteed if the installation and service instructions are correctly
followed.
2.3
Warning for installation and assembly tasks
Electrical connections
See also the document:
Electrical system, safety distances and danger zones for SPA pools with hydromassage.
The motor must be wired according the local standards: - if in doubt consult a qualified electrician. Check supply voltage
complies with voltage on motor plate.
When connecting electric cables to the motor of the machine, be careful to correctly arrange them inside the connection
box, verify that no bits of cable are left inside on closing it, and see that the earth wire is correctly connected.
Be especially careful that no water whatsoever enters the motor or the electrical parts under voltage.
In the event that the planned use is not as specified, adaptations and supplementary technical rules may be necessary.
