Albatron PX915G4 PRO, Руководство пользователя

Страница: 40 / 54

PX915P4/ PX915G4 Series
UR2 Duplex Mode
Select the transmission mode used by the IR interface. Full-duplex mode permits simultaneous
bi-directional transmission. Half-duplex mode permits transmission in only one direction at a time. This
field only configurable if “UART Mode Select” is set to “ASKIR” or “IrDA”. Options: Half (default)
、
Full
Use IR Pins
Consult your IR peripheral documentation to select the correct setting of the TxD and RxD signals. This
field is only configurable if “UART Mode Select” is set to “ASKIR” or “IrDA”.
Options: RxD2
、
DxD2 (default)
Onboard Parallel Port
Select an address and corresponding interrupt for the onboard parallel port.
Options: 378/IRQ7 (default)
、
278/IRQ5
、
3BC/IRQ7
、
Disabled
Parallel Port Mode
This option allows you to select a parallel port mode for the onboard parallel port.
Options:
ECP (default) Extended Capabilities Port.
EPP Enhanced Parallel Port.
SPP Standard Printer Port.
ECP+EPP ECP & EPP mode.
Normal
EPP Mode Select
Select EPP port type 1.7 or 1.9. This field is only configurable if “Parallel Port Mode” is set to “EPP” or
“ECP+EPP”. Options: EPP 1.9(default)
、 EPP 1.7
ECP Mode Use DMA
Select a DMA Channel for the parallel port when using the ECP mode. This field is only configurable if
“Parallel Port Mode” is set to “ECP”. Options: 3 (default)
、
1
PWRON After PWR-Fail
This field will determine whether your system will boot after restoring power after a power failure. If you
select “On”, the system will boot whether or not the system was on before power failure. If you select
“Former-Sts”, the system will be restored to the status before the power failure. Options: Off (default)
、
On
、
Former-Sts
36