PX865PEC PRO
34
Suspend Mode = 1 minute
HDD Power Down = 1 minute
3. User Defined (default)
Allows you to set each mode individually.
When this option is enabled, each of the ranges are from 1 minute to 1 hour except for HDD Power
Down, which ranges from 1 minute to 15 minute and includes a “disable” option.
Note: If you select Min. or Max. Power Saving modes, the “HDD Power Down” value and the
“Suspend Mode” value are both fixed.
Video Off Method
This option determines the manner in which the monitor goes blank.
Options:
V/H SYNC+Blank
This selection will cause the system to turn off the vertical and horizontal
synchronization ports and write blanks to the video buffer.
Blank Screen(default) This option only writes blanks to the video buffer.
DPMS Support
Initial display power management signaling.
Video Off In Suspend
This determines whether power to the monitor is switched off when the computer is in suspend mode.
Options: Yes
、
No (default)
Suspend Type
This item allows you to select the suspend type under the ACPI operating system.
Options: Stop Grant (default)
、
PwrOn Suspend
Modem Use IRQ
This determines the modem’s IRQ. Options: 3 (default)
、
4
、
5
、
7
、
9
、
10
、
11
、
NA.
Suspend Mode
This item allows you to select the suspend time under the ACPI operating system.
Options: Disabled(default)
、
1Min
、
2Min
、
4Min
、
8Min
、
12Min
、
20Min
、
30Min
、
40Min
、
1Hour
HDD Power Down
When enabled, the hard disk drive will power down after a certain configurable period of system
inactivity. All other devices remain active.
Options: Disabled (default)
、
1 Min
、
2 Min
、
3 Min
、
4 Min
、
5 Min
、
6 Min
、
7 Min
、
8 Min
、
9 Min
、
10 Min
、
11 Min
、
12 Min
、
13 Min
、
14 Min
、
15Min
Soft-Off by PWRBTN
In situations where the system enters a “hung” state, you can configure the BIOS so that you are
required to pre the power button for more than 4 seconds before the system enters the Soft-Off state.
Options: Delay 4 Sec, Instant-Off (default).
