PX865PE PRO II
38
Onboard FDC Controller
stem board and
ou wish to use it. If you install an add-in FDC or the system has no floppy drive, select “Disabled”.
g interrupt for the first/ second serial port.
efault for port1)
、
2F8/IRQ3(default for port2)
、
3E8/IRQ4
、
ptions: Normal (default)
、
ASKIR
、
IrDA
his item determines the RxD and TxD frequencies. This field is only configurable if “UART Mode
: Hi / Lo (default)
、
Hi / Hi
、
Lo / Hi
、
Lo / Lo
ed
R2 Duplex Mode
used by the IR interface. Full-duplex mode permits simultaneous
ptions: Half (default)
、
Full
etting of the TxD and RxD signals.
his field is only configurable if “UART Mode Select” is set to “ASKIR” or “IrDA”.
upt for the onboard parallel port.
ptions: 378/IRQ7 (default)
、
278/IRQ5
、
3BC/IRQ7
、
Disabled
Select “Enabled” if your system has a floppy disk controller (FDC) installed on the sy
y
Options: Enabled (default)
、
Disabled
Onboard Serial Port 1/ Port 2
Select an address and correspondin
Options: Disabled
、
3F8/IRQ4 (d
2E8/IRQ3
、
Auto
UART Mode Select
This item allows you to select the Infra Red (IR) standard to be used.
O
RxD, TxD Active
T
Select” is set to “ASKIR” or “IrDA”. Options
IR Transmission Delay
This item allows you to enable/disable IR transmission delay. This field is only configurable if
“UART Mode Select” is set to “ASKIR” or “IrDA”. Options: Enabled (default)
、
Disabl
U
Select the transmission mode
bi-directional transmission. Half-duplex mode permits transmission in only one direction at a time.
This field is only configurable if “UART Mode Select” is set to “ASKIR” or “IrDA”.
O
Use IR Pins
Consult your IR peripheral documentation to select the correct s
T
Options: Full
、
Half (default)
Onboard Parallel Port
Select an address and corresponding interr
O
