PX865PE PRO II
36
IDE Primary/Secondary/Master/Slave
The IDE PIO (Programmed Input / Output) fields let yo
PIO
u set a PIO mode (0-4) for each of the IDE
devices that the onboard IDE interface supports. Modes 0 to 4 will increase performance
entally. In Auto mode, the system automatically determines the best mode for each device.
ptions: Auto (default)
、
Mode0
、
Mode1
、
Mode2
、
Mode3
、
Mode4.
E Primary / Secondary /Master / Slave UDMA
ltra DMA 100 functionality can be implemented if it is supported by the IDE hard drives in your
stem. As well, your operating environment requires a DMA driver (Windows 95 OSR2 or a third
arty IDE bus master driver). If your hard drive and your system software both support Ultra DMA
00, select “Auto” to enable BIOS support. Options: Auto (default)
、
Disabled
**OnChip Serial ATA Setting***
TA Mode
hen the “On-Chip Serial ATA” set to the “Combined Mode” and this item will allowsyou to select
e SATA Mode. Options: IDE (default)
、
RAID
ced Mode
、
SATA Only
/ 1 Mode
ip PCI Device” label and then press the enter key, it will take you
higher performance controller.
ptions: Enabled (default)
、
Disabled
abled
increm
O
ID
U
sy
p
1
*
SA
W
th
On-Chip Serial ATA
This item allows you to enable or disabled the on-chip serial ATA function.
Options: Disabled (default)
、
Auto
、
Combined Mode
、
Enhan
Serial ATA Port0
This item allows you to select the Serial ATA device mode for port 0 & 1.
Options: Primary Master
、
Primary Slave
、
Secondary Master
、
Secondary Slave
Onboard Device
If you highlight the “INTEL OnCh
to a submenu with the following options:
USB Controller
This option should be enabled if your system has a USB port installed on the system board. You will
need to disable this feature if you add a
O
USB 2.0 Controller
This option should be enabled if your system has a USB 2.0 device installed on the system board.
You will need to disable this feature if you install a USB 1.1 device.
ptions: Enabled (default)
、
Dis
O
