PX845PEV/ GEV Series
41
Onboard Serial Port 2
Select an address and corresponding interrupt for the second serial port.
Options: Disabled
、
2F8/IRQ3 (default)
、
3F8/IRQ4
、
3E8/IRQ4
、
2E8/IRQ3
、
Auto
UART Mode Select
This item allows you to select the Infra Red (IR) standard to be used.
Options: Normal (default)
、
AS KIR
、
IrDA
RxD, TxD Active
This item determines the RxD and TxD frequencies.
Options: Hi / Lo (default)
、
Hi / Hi
、
Lo / Hi
、
Lo / Lo
IR Transmission Delay
This item allows you to enable/disable IR transmission delay.
Options: Enabled (default)
、
Disabled
UR2 Duplex Mode
Select the value required by the IR device connected to the IR port. Full-duplex mode
permits simultaneous bi-directional transmission. Half-duplex mode permits transmission in
only one direction at a time.
Options: Half (default)
、
Full
Use IR Pins
Consult your IR peripheral documentation to select the correct setting of the TxD and RxD
signals.
Options: Full
、
Half (default)
Onboard Parallel Port
Select an address and corresponding interrupt for the onboard parallel port.
Options: 378/IRQ7 (default)
、
278/IRQ5
、
3BC/IRQ7
、
Disabled
Parallel Port Mode
This option allows you to select an operating mode for the on board parallel printer port.
ECP(default) ECP means that using Parallel port as Extended Capabilities Port.
EPP
Using Parallel Port as Enhanced Parallel Port.
SPP
Using Parallel port as Standard Printer Port.
ECP+EPP
Using Parallel port as ECP & EPP mode.
Normal
EPP Mode Select
Select EPP port type 1.7 or 1.9.
Options: EPP 1.9(default)
、
EPP 1.7
