KX600S PRO/ KX600S
35
USB Controller
This option should be enabled if your system has a USB port installed on the system board. You will
need to disable this feature if you add a higher performance controller.
Options: All Enabled (default)
、
All Disabled
OnChip EHCI Controller
This option should be enabled if your system has a USB 2.0 device installed on the system board.
You will need to disable this feature if you install a USB 1.1 device.
Options: Enabled (default)
、
Disabled
USB Device Support
Enables support for USB attached devices. Options: Disabled (default)
、
Enabled
Super IO Device
If you highlight the literal “Press Enter” next to the “Super IO Device” label and then press the enter
key, it will take you a submenu with the following options:
Onboard FDC Controller
Select Enabled if your system has a floppy disk controller (FDC) installed on the system board and
you wish to use it. If you install an add-in FDC or the system has no floppy drive, select “Disabled”
in this field. Options: Enabled (default)
、
Disabled
Onboard Serial Port 1
Select an address and corresponding interrupt for the first serial port.
Options: Disabled
、
3F8/IRQ4 (default)
、
2F8/IRQ3
、
3E8/IRQ4
、
2E8/IRQ3
、
Auto
Onboard Serial Port 2
Select an address and corresponding interrupt for the second serial port.
Options: Disabled
、
2F8/IRQ3 (default)
、
3F8/IRQ4
、
3E8/IRQ4
、
2E8/IRQ3
、
Auto.
Onboard Parallel Port
This item allows you to determine the parallel port interrupt and address.
Options: 378/IRQ7 (default)
、
278/IRQ5
、
3BC/IRQ7
、
Disabled
This Manual: http://www.manuallib.com/file/2538033
