K7I741CX Mainboard
16
Chapter 2. BIOS Setup
Introduction
This section describes PHOENIX-AWARD™ BIOS Setup program which resides in the BIOS
firmware. The Setup program allows users to modify the basic system configuration. The
configuration information is then saved to CMOS RAM where the data is sustained by battery after
power-down.
The BIOS provides critical low-level support for standard devices such as disk drives, serial ports
and parallel ports. As well, the BIOS control the first stage of the boot process, loading and executing
the operating system.
The PHOENIX-AWARD
TM
BIOS installed in your computer system’s ROM is a custom version of
an industry standard BIOS. This means that it supports the BIOS of Intel
®
based processors.
This version of the PHOENIX-AWARD
TM
BIOS includes additional features such as virus and
password protection as well as special configurations for fine-tuning the system chipset. The defaults
for the BIOS values contained in this document may vary slightly with the version installed in your
system.
Key Function
In general, you can use the arrow keys to highlight options, press <Enter> to select, use the <PgUp>
and <PgDn> keys to change entries, press <F1> for help and press <Esc> to quit. The following table
provides more detail about how to navigate within the BIOS Setup program.
Keystroke
Function
Up arrow
Move to previous option
Down arrow
Move to next option
Left arrow
Move to the option on the left (menu bar)
Right arrow
Move to the option on the right (menu bar)
Esc
Main Menu: Quit without saving changes
Submenus: Exit Current page to the next higher level menu
Move Enter
Move to the option you desire
PgUp/ PgDn key
Increase/ Decrease the numeric value or enter changes
+/ - Key
Increase/ Decrease the numeric value or enter changes
Esc key
Main Menu – Quit and do not save changes into CMOS
Status Page Setup Menu and Option Page Setup Menu – Exit
Current page and return to Main Menu
F1 key
General help on Setup navigation keys
F5 key
Load previous values from CMOS
F6 key
Load the optimizd defaults from BIOS default table
F7 key
Load the standard defaults from BIOS default table
F10 key
Save all the CMOS changes and exit
