7.
CONFIGURE THE TV
The DVD player is set to UK PAL TV type as standard; if NTSC is required, see section 20 for set up.
7.1
Place the DVD player horizontal on a flat level surface.
7.2
Connect the DVD player to your TV and / or audio system (as shown in the previous diagrams), plug in
and switch on at the mains.
7.3
Insert the batteries into the remote control.
7.4
Press the POWER button
on the DVD player
to turn on the player (the power indicator at the side of the
button will illuminate) and turn on the TV and amplifier (if connected).
7.5
Select the video mode (AV) for the TV. If there is more than one video channel (AV1, AV2, etc) select the
source that the DVD player is connected to. See the TV instruction manual for tuning instructions if the set
does not automatically tune.
CAUTION !
ALL EQUIPMENT MUST BE TURNED OFF AND DISCONNECTED FROM THE MAINS BEFORE
INSTALLATION
SCART
OUTPUT
VIDEO
L
R
S-VIDEO
110-240V~
50/60Hz
White
Red
Yellow
White
Red
Yellow
1
.
Use
the
supplied
AV
cable
to
connect
the
DVD
player’s
AUDIO
(
L/R
)
sockets
to
a
stereo system’s
analogue audio
sockets.
(
Audio Left=white
,
and
Audio
Right=red
)
2
.
Connect
the
DVD
player’s
video
output
(
Y/ Pb/Cb/ Pr/Cr
)
socket to
a
TV’s
video
input socket
by
using a Y/ Pb/Cb/ Pr/Cr
cable
.
3
.
Turn
the
DVD
player
,
your
TV
and
stereo
system
on
.
4
.
Adjust
the
input
source
of
your
TV
and
stereo
system
to
receive the
external
signals from
the
DVD
player
.
Please
refer
to
the instruction
manuals
of
your
TV
and
stereo system
for
details
.
Stereo
System
Y
Pb/Cb
Pr/Cr
Method 2
:
Connecting to a Stereo System and TV with an
AV Cable and
Cable
Y/ Pb/Cb/ Pr/Cr
6
