Page 4
Radio operation (cont)
NOTE:
FM frequencies run at the top of the dial & MW (AM) frequencies
along the bottom.
For FM reception:
you will need to extend the
FM
antenna fully, and in some
cases move it around until you receive the best possible signal.
For MW reception:
the built-in ferrite antenna is used, meaning to receive the
best signal you may need to move the entire unit around until the best signal is
found.
Cassette operation
Cassette playback
1:
Set the
FUNCTION SELECTOR
switch to the
OFF/TAPE
position
2:
Press the
STOP/EJECT
button to open the cassette door, insert a cassette into
the compartment and close the door.
3:
Press the
PLAY
button, and adjust to the required volume level. When the tape
comes to the end it will automatically stop and the button will release.
4:
During playback the cassette can be fast forwarded by pressing down the
FAST FWD
button or rewound with the
REWIND
button. Pressing
STOP/EJECT
will cancel all functions.
5:
To pause playback of a cassette press the
PAUSE
button, to enable playback
press the
PAUSE
button again.
6:
To eject the cassette press the
STOP/EJECT
button to cancel any functions,
then press again to open the cassette compartment door and remove the
cassette.
Cassette operation (cont)
Recording from the Radio / CD
1:
Set the
FUNCTION SELECTOR
switch to the
RADIO
or
CD
position.
2:
Tune in the radio station you wish to record
(see Radio Operation Page 3)
, or
load a
CD (see CD Operation Page 4)
Insert a blank
(recordable)
cassette into
the unit.
3:
Press the
RECORD
and
PLAY
button at the same time to start recording.
4:
When finished press the
STOP/EJECT
button. or leave the recording until the
cassette reaches the end where it will stop automatically.
CD operation
General playback
1:
Set the
FUNCTION SELECTOR
switch to the
‘CD’
position.
2:
Open the
CD
lid using the
OPEN/CLOSE
latch. Load a compatible disc with the
label facing upwards.
3:
The unit will scan the disc and then display the total number of tracks on the
LED DISPLAY.
4:
Press the
CD-PLAY/PAUSE
button to begin playback. The current track number
will be displayed on the
LED DISPLAY
and a dot will appear on the display.
User instructions
OFF
OFF
