Section 4
Installation
4.1 Mounting
4.1.1 Mount the unit in locations that meet the following temperature and humidity requirements.
Do not expose to conditions outside of these ranges.
32 °C (90 °F) @ 93%
Humidity
0 °C to 49 °C (32 °F to 120 °F)
Temperature
Mount the unit in a standard 19" equipment rack using the appropriate hardware for the rack.
CAUTION - A fully loaded RMBE can weigh more than 31 pounds, as installed. Care must be
taken when installing to prevent injury to the installer. Also, ensure that the rack into
which the RMBE is being installed can withstand the total weight of the equipment
installed. The RMBE should be installed near the bottom of the rack to ensure rack stability.
Install batteries into the RMBE enclosure (See Section 4.1.2)
Ensure all back panel jumpers are removed before installing into the rack
Locate an open 2RU slot in the rack and remove the filler panel(s), if present
Slide the unit into the open slot from the front of the rack
Install the four mounting screws into the end brackets of the unit
4.1.2 Installing or Replacing the Battery Set(s)
All batteries degrade with time and environment - periodic inspection and replacement is required.
Figure 4.1.2.1
Rack Mount Battery Enclosure Installation Instructions
5/27/2009, 11:42:41 AM
52-342 Rev A.01
Page 7 of 14
AlarmSaf
65A Industrial Way, Wilmington, MA 01887 978 658 6717 www.alarmsaf.com
