3.
Press
Key
[3]
to advance to the second digit and repeat Step 2 to program the second digit.
Repeat Steps 2 and 3 until 4 digits have been programmed.
4. To return to the first digit of Arm/Disarm Code 1 at any time, redial location “B11”. (For
Codes 2, 3, or 4, redial location “B12
,
”
“B13”, or “B14”.) To check any Arm/Disarm Code, dial
its location, then press Key [3] repeatedly to step through the code digit by digit.
5. If the code is satisfactory, exit the Program Mode: Press Keys [*] and [#] at the same time.
Caution:
Pressing these keys again - after the three lights have gone out - will signal a panic
alarm!
6
.
Important:
Arm and disarm in succession. This checks the validity of the code and, if
accepted, stores it in memory as the new Arm/Disarm Code.
7. If you cannot arm, either your code has not been accepted or you entered a wrong number.
Try your code again. (Remember, you must wait at least 2 seconds after entering a wrong code.)
If your code is still being rejected, you may re-enter the Program Mode directly by holding
down Key [8] (the three lights will come on), and reprogram that code, or a different one. Then
repeat Steps 5 and 6.
Programming Entry and Exit Delays (Locations B15 and Bl6)
.
Determine the amount of time
that you will need to enter and disarm your system; this number will be programmed in location
B15 as the Entry Delay. Similarly, determine the amount of time that you will need to arm
your system and exit the premises; this number will be programmed in location B16 as the Exit
Delay. Delay times are programmed in lo-second increments. Select suitable entries from the
following table.
Entry Delay Time
1 10 seconds
Entry Delay Time
6 60 seconds
110 seconds
2 20 seconds 7 70 seconds C 120 seconds
3 30 seconds 8 80 seconds d 130 seconds
4 40 seconds 9 90 seconds E 140 seconds
5 50 seconds 0 100 seconds F 150 seconds
To program Entry and Exit Delays, proceed as follows:
1. Hold down Key
[8]
until the beep sounds.
2.
Within 5 seconds
enter your Arm/Disarm Code. The three lights will come on and the display
will show the first digit of your code.
Caution:
If only the red light comes on, you waited too long before entering your Arm/Disarm
Code, and armed the panel. Enter your code again to disarm before proceeding.
3. Dial location “B15”; a beep will sound. Press Key
[1]
repeatedly until the
Entry Delay
value
(chosen from the table) appears in the display.
4. Dial location “B16”; a beep will sound. As above, press Key [1] repeatedly until the
Exit
Delay value (chosen from the table) appears in the display.
5. Check either delay time by dialing its respective location. If the delays are satisfactory, exit
the Program Mode: Press Keys [*] and [#] at the same time.
6. Arm and Disarm the system. (If you cannot arm, see
Changing Arm/Disarm Codes 1-4,
Step
7.)
9
