Troubleshooting
• If you have issues connecting the camera to the account,
power cycle the camera and try again.
• If issues persist, press and hold the Reset button
located on the bottom of the camera until the LED is
blinking green and red (about 15 seconds), then release
the button. The camera will reboot with factory
default settings.
If the camera was previously installed to an
Alarm.com account, it will need to be deleted
before it can be installed again.
Questions?
Visit answers.alarm.com
or contact your service provider.
Notices
Federal Communication Commission
interference statement
This equipment has been tested and found to comply with the limits for a
Class B digital device, pursuant to part 15 of the FCC Rules. These limits are
designed to provide reasonable protection against harmful interference in a
residential installation. This equipment generates, uses and can radiate radio
frequency energy and, if not installed and used in accordance with the
instructions, may cause harmful interference to radio communications.
However, there is no guarantee that interference will not occur in a
particular installation. If this equipment does cause harmful interference to
radio or television reception, which can be determined by turning the equipment
off and on, the user is encouraged to try to correct the interference by one or
more of the following measures:
•
Reorient or relocate the receiving antenna.
•
Increase the separation between the equipment and receiver.
•
Connect the equipment into an outlet on a circuit different from that to
which the receiver is connected.
•
Consult the dealer or an experienced radio/TV technician for help. Changes or
modifications not expressly approved by the party responsible for compliance
could void the user’s authority to operate this equipment.
IC statement
This device contains licence-exempt transmitters(s)/receiver(s) that comply
with Innovation, Science and Economic Development Canada’s licence-exempt
RSS(s). Operation is subject to the following two conditions:
•
This device may not cause interference.
•
This device must accept any interference, including interference that may
cause undesired operation of the device.
Cet appareil contient des émetteurs/récepteurs exemptés de licence conformes
à la norme Innovation, Sciences, et Développement économique Canada.
L’exploitation est autorisée aux deux conditions suivantes:
•
L’appareil ne doit pas produire de brouillage.
•
L’utilisateur de l’appareil doit accepter tout brouillage radioélectrique subi,
même si le brouillage est susceptible d’en compromettre le fonctionnement.
6
7
