Alarm.com Smart Thermostat
Product Manual
| 13
Configure The System
Check The System
The thermostat configuration will be done on
your online account. Here you can configure the
parameters of the system, such as: Heat Pump or
Normal, number of heat and cool stages, heating
fuel, calibration temperature, and configurable
terminal (Z). In your online account, you will have
to enter the thermostat configuration. Refer to
page 9 for the appropriate diagrams when you
set up the thermostat.
While the default settings will be sufficient in
most cases, you also have the option to change
advanced configuration settings, such as: Swing,
Differential, Recovery Setting, Fan Circulation
Period and Duty Cycle, Maximum Set Points,
Minimum Set Points, Thermostat Lock, and
Modes Enabled.
WARNING: Use caution when changing
advanced configuration settings. These
configuration settings should only be changed
by those familiar with heating and cooling
systems’ parameters. Contact a local HVAC
professional for help.
WARNING: Do not test the AC during cold
weather or heat during hot weather. Wait
for mild weather to fully test the system.
To Check Heating
1.
Press the
MODE
( ) button to select
HEAT
( )
mode.
2.
Press the
UP
(
) button to raise the set point
above room temperature.
3.
Wait 5 minutes for the system to turn on.
4.
After verifying the heating system is working,
return the set point to the desired temperature.
To Check Cooling
1.
Press the
MODE
button ( ) to select
COOL
( )
mode.
2.
Press the
DOWN
(
) button to lower the set
point below room temperature.
3.
Wait 5 minutes for the system to turn on.
4.
After verifying the cooling system is working,
return the set point to the desired temperature.
