Setup
9
2) Gently slide the battery pack toward the transceiver’s back edge
keeping it slightly pressed onto the metallic back surface.
3) At approx. 1.5 cm you will feel the battery’s guides fitting with the
transceiver’s ones (the battery pack will be closer to the transceiver).
Keep on sliding the battery pack toward the back edge.
4) At the end you will hear a click: the battery pack will snap into
place and should be firmly locked.
To remove the battery pack:
1) Press the battery release button located in the back of the battery
pack.
2) Keep the button pressed and gently pull the battery pack away
from the transceiver back edge (the opposite operation of the
previous step 2): it will stop at 1.5 cm approximately and will be
free.
3) Remove the battery pack by separating it from the transceiver’s
body.
Installing/removing the belt clip
The supplied belt allows you to hang the transceiver up to your belt
or jacket when you are not using the radio and you are just in stand-
by condition (ready to receive calls).
To fit the belt clip onto the transceiver’s body:
1) Remove the battery pack as explained in “Installing/removing the
battery pack”.
2) Just gently slide the clip into the appropriate guides located in
the transceiver’s back until it firmly locks.
To remove the belt clip:
1) Remove the battery pack as explained in “Installing/removing the
battery pack”.
2) Reverse the over stated step 2.
I
Don’t forget to remove the battery pack before fitting/removing
the belt clip, otherwise the operation may result harder to
perform. Moreover the battery case might be accidentally
scratched.
Charging the battery pack
To charge the supplied battery pack you have to setup the supplied
standard charger and connect the radio as follows (please see the
picture):
English
1
A
B
C
2
D
E
F
3
G
H
I
4
J
K
L
7
S
T
U
5
M
N
O
8
V
W
X
6
P
Q
R
9
Y
Z
-
C
A
L
L
C
L
R
0
MENU
®
To the AC outlet