Alan HM06 Series, Руководство пользователя

Страница: 13 / 20

English
5.7 Transmission
1) Remove the microphone from the support.
2) Verify that the channel is free (to prevent potential interference)
and check that the status LED [9] on the right of the display is
off.
3) Press and hold down the palm-sized microphone transmission
key (PTT) . The status LED turns red.
4) Speak normally at a distance of
5-10 cm
from the microphone.
5) Release the PTT key at the end of the call making sure that the
status LED switches off.
6) At the end of the conversation, place the microphone back onto
its support.
2
Start talking only after pressing the PPT key and release it only
after the conversation has ended, otherwise the transmission of
the message may be incomplete.
2
Do not shout! Shouting does not increase the transmission dis -
tance but affects the quality of the signal received.
2
Transceivers cannot generally be used to listen and talk simulta -
neously. For this reason, you will not be able to talk when others
are talking. It is therefore advisable to time your messages so that
they are not too long.
2
For information on how to transmit correctly, see the following
paragraphs.
5.7.a Maximum Time Out Timer (TOT)
The radio has a programmed Time Out Timer that automatically
enables the reception mode if the speaker's message exceeds a
specific time limit. The setting of this timer can be configured during
the programming phase. If this occurs, release the transmission key
and wait a few seconds to allow the radio transmission feature to be
automatically reset. For additional information, contact the radio link
provider or your local dealer.
2
This setting cannot be changed by the user. For more information,
contact the radio link provider.
5.7.b Blocking transmission when the channel is busy (BCLO)
If enabled, this feature prevents the transmission of outgoing signals
if the channel is busy. In this case the use of the
PTT key has no
effect.
Depending on programming, the BCLO feature can be enabled for all
signals and for signals with a specific CTCSS/DCS code/tone.
2
This setting cannot be changed by the user. For additional infor -
mation, contact the radio link provider.
5.7.c Selecting the transmission strength
The transceiver can transmit with the transmission strengths config -
ured during the programming phase for each channel. The red LED hI
indicates that the following strength has been selected:
• On - High strength
• Off - Low strength
To change the strength of a specific channel, select it and press the
f key (or ) linked to this feature. The red hI LED confirms that the