AL-KO G2033022, Руководство по эксплуатации

Страница: 32 / 300

GB
32 HT 4260
Working behaviour and working technique (12)
8.6 Eco Mode / Power Mode (10)
The appliance is equipped with an Eco Mode/
Power Mode mode. Select between the Eco
Mode (approx. 1200 min
-1
) and the Power Mode
(approx. 1500 min
-1
) by pressing the button
(10/1).
If the Power Mode is switched on, the green LED
display lights.
If the appliance is switched off and then switched
on again, it starts with the previously selected
setting.
9 WORKING BEHAVIOUR AND
WORKING TECHNIQUE (12)
WARNING!
Increased risk of falling
There is a greater risk of falling if work is
carried out from an elevated position
(e.g. ladder).
■
always work with the appliance from
the ground and make sure that you
are standing securely.
■
Heed the safety instructions.
■
Cut the hedge regularly and only at the per-
mitted times.
■
Only cut off the thin branches and new
growth on the surface of the hedge; do not
cut too deep.
■
Always cut the two sides of a hedge first, fol-
lowed by the top. This prevents cut material
from falling into areas that you have not yet
trimmed.
■
Hedges should always be trimmed into a
trapezoidal shape (tapering toward the top).
This prevents the leaves on the lower
branches from being shaded out (12).
■
Make sure the motor is stopped before you
remove any cuttings.
■
When leaving/transporting the appliance:
■
Switch off the appliance.
■
Fit the protective cover.
■
Remove the battery.
■
After use, remove the battery and check the
appliance for damage.
10 MAINTENANCE AND CARE
WARNING!
Danger of cutting injuries
Danger of cutting injuries when reaching
into sharp-edged, moving appliance
parts and into cutting tools.
■
Before maintenance, care and
cleaning work, always switch off the
appliance. Remove the recharge-
able battery.
■
Always wear protective gloves
during maintenance, care and clean-
ing work.
NOTE
Repair work is only allowed to be carried
out by expert workshops or our AL-KO
service centres.
■
Do not get the appliance wet or expose it to
moisture.
■
After each use, clean the housing and cutting
blades with a brush or cloth. Do not use wa-
ter and/or aggressive cleaning agents or sol-
vents - risk of corrosion and damage to the
plastic parts.
■
Remove the battery and check for damage
after each use.
■
Clean the cutting blade and spray with rust-
proofing oil.
■
Regularly check the cutting blade. Contact an
AL-KO service centre under the following cir-
cumstances:
■
Defective cutting blade
■
Blunt cutting blade
■
Excessive wear
■
Check all screws for tightness.
■
Check the electrical contacts on the appli-
ance for corrosion, clean with a fine wire
brush if necessary and then spray with a con-
tact spray.
11 TRANSPORT
Before transporting, carry out the following mea-
sures:
1. Switch off the tool.
2. Remove the rechargeable battery from the
appliance.
3. Pack the battery properly.