TUN/GREEN button function (6)::
Faster turning speeds up the regulation, with the number of regulation steps per knob step being dependent on the turning speed. This makes it possible to achieve the desired parameter value with a small
knob stroke and at the same time to set the selected parameter precisely.
Approximately two seconds after stopping turning the knob, the controller switches the automatically adjustable parameter to the default one. In CCT mode, the default parameter to edit is DIM, and in HSV
mode, the VAL parameter. In RGB mode, automatic restore to default parameter does not work.
Turning the dial (8) changes the value of the currently selected parameter.
Turning to the right increases the parameter and turning to the left decreases it.
DAY/BLUE button function (7):
The encoder knob (8) has a dynamic precision control.
Slowly turning the knob changes the adjustable parameter by one step, for each step of turning the knob.
- in CCT mode, pre-selects light tungsten CCT = 3200K GM = 0 (OFF), DIM - no change
- in RGB mode, it loads blue light: R = 0, G = 0, B - the maximum of the current RGB values
One of the three editable light parameters
is selected by pressing the encoder knob (8). The currently selected parameter is marked with ">"(10).
- in HSV mode, it loads the blue light: HUE = 240 °, SAT = 100%, VAL - the current value
- in RGB mode, it loads the green light: R = 0, B = 0, G - the maximum of the current RGB values
- in CCT mode, it preselects daylight CCT = 5650K GM = 0 (OFF), DIM - no change
- in HSV mode, it loads the green light: HUE = 120°, SAT = 100%, VAL- the current value
SECT
OR
MODE
TUN/GREEN
D
AY/BL
UE
10
4
6
5
7
Fig.2
SECTOR Controller buttons
S E C T O R
