Akura ATLDVD3230W-HD, Инструкция по эксплуатации

Страница: 26 / 29

Should you experience problems. Please consult the table below before returning to the place of
purchase.
SYMPTOM POSSIBLE CAUSE REMEDY
GENERAL
No power to the TV Check all connections to the Tv
including the mains input leads.
Dead No Led lit
Mains Switch turned Off Turn the Mains Switch at the rear
On
Dead. Led lit Blue Set still in Standby
Press the Power button, or a
Channel number button or
CH+/CH- buttons
Tv not tuned in
No Signal
Connect suitable aerial
Incorrect source selected. Press TV/AV button to select
correct source.
Blue Screen
Source not turned on Turn external source on
If using an indoor aerial try
moving the aerial.
Check aerial connections.
Noisy, snowy, ghosting picture
(TV) Poor aerial signal
Have an outdoor aerial fitted
Incorrect sound system selected Check “system” select in
“SETUP” menu see page 13
Sound “Mute” selected Turn sound “Mute” Off
No sound
External leads not connected “if
used” Check all external leads are
connected
Bright dots on screen. Pixel turned on fully
Occasionally one or two pixels
may fail, this is normal as the
screen ages or suffers an impact.
This is NOT a fault covered by
warranty
DVD
Will not accept disc DVD not selected Select DVD with TV/AV button
Screen shows “No Disc” Disc placed incorrectly Disc must be placed with mirror
side facing forwards “if single
sided”
Certain disc functions not working Disc may not support required
feature
Read disc information
PC Monitor
Unstable picture
Monitor may not be set to PC
correctly.
PC Screen refresh rate is set too
high
Enter the SETUP menu in VGA
mode and select “AutoSync” see
page 15
Enter PC Screen Setup and set
refresh rate at 60Hz
Remote Control
s h t n o m 6 h c a e s e i r e t t a b e c a l p e R s e i r e t t a b w o L Intermittent or no remote control
operation
Object blocking I/R beam Remove any obstacles