AKO AKO-575 Series, Руководство пользователя

Страница: 9 / 28

5750H002 Ed.03
9
ON
OFF
1
2
Setup wizard
1 -.The first time the transmitter receives the power supply, it will enter
into ASSISTANT mode. The display will show the message In{
flashing with 0 .
2 -.Using keys
N
and
Q
, select one of the options depending on the
type of installation and press SET to confirm:
InI = 0 : Demo mode* InI = 1 : Connection to alarm station
InI = 2 : Independent operation
If 1 minute elapses without any key being pressed, the
transmitter will automatically proceed to demo mode*.
AKO-575400 only
3 -.The display will show the message Gc2 . Use keys
N
and
Q
to
select the type of gas to be measured (ALL, 134A, 404A, 407A,
410A, 125, 448A, 449A or 407F , and press
SET to confirm. )
All models
The transmitter will begin to operate normally.
If the transmitter is connected to an alarm station, initiate the setup wizard in the
transmitter before doing so in the station.
This function will not reactivate once the transmitter has been configured. To reactivate the function,
disconnect the power supply, reconnect it and press
N
,
Q
and SET before 2 minutes are up.
4 -.If this is not the first time you initiate the wizard, after completing the last step the display will show the
message dFp (parameters per defect). You may choose between two options:
0: Only changing the parameters which affect the wizard (
Gc2
,
b04
and
o00
). The other parameters will
remain the same.
1: All parameters return to their factory setting except those which have been modified by the wizard.
It is advisable to reset to zero on start-up. See the different methods on page 21.
* * Demo mode shows the reading of the gas concentration on a flashing panel with the message Inl . It does not
activate Alarms or Pre-Alarms. This mode allows postponement of the configuration of the transmitter.