1.- Introduction
2.- Versions and references
3
Alarm module with remote control via GSM, with 4 digital inputs and two output relays.
The alarms detected in any of its inputs will be communicated sequentially by SMS to the 10 telephone numbers
saved in its internal phone book until one of them confirms their reception.
It also allows activating or deactivating at will any of the 2 output relays, using SMS messages.
The module is powered by the 230 V~ mains supply and incorporates a battery that guarantees its operation in the
event of a power failure.
It incorporates additional functions such as sending alerts in the event of a power failure or in the event of its
reestablishment, status query, etc.
.- Maintenance and warnings
IMPORTANT
-The
start-up time
from when the power supply is connected until the unit is operating is
approximately 2 minutes.
-The SIM card
must have the PIN code disabled
before being installed in the alarm, refer to the
installation chapter.
-If you use a prepaid SIM card remember to regularly check that you have enough credit and its expiry
date, consult your GSM operator.
-When the unit is connected for the first time, the
initial battery loading
will start and this process
wi
).
Ÿ
Clean the surface of the equipment with a soft cloth, water and soap.
Ÿ
Do not use abrasive detergents, petrol, alcohol or solvents.
Ÿ
The wiring of the alarm input signals should
NEVER
be installed in a conduit together with power, control or
feeder cables.
Ÿ
Using the unit not observing the manufacturer's instructions may alter the appliance's safety requirements.
Ÿ
The unit should be installed in a place protected from vibrations, water and corrosive gases, where the
ambient temperature does not exceed the value indicated in the technical data.
Ÿ
The power circuit should be equipped with a switch for its disconnection of at least 2 A, 230 V, situated near
the appliance. The cables will be H05VV-F or H05V-K.
2
Ÿ
The section to be used will depend on current local regulations, but should never be less than 1 mm .
ll last approximately 2 h, during which power failure alert messages can be generated.
-The alarm is supplied with the battery disconnected; please remember to connect it at the time of
installation (see pg.
17
Units that include rechargeable electrical accumulators:
This unit includes accumulators that should be replaced when the unit's battery life is under the duration
assigned in its specifications. At the end of the useful life of the unit, the accumulators should be taken
to a selective waste collection centre or returned to the manufacturer.
MODEL
DESCRIPTION
INCLUDED
AKO-52044
GSM Alarm module
Yes
AKO-520441
Optional external antenna with 2 m of cable
No
English
15
5204H401 Ed.01
