Page 35 of 56
9.
Starting with the switch outside the chassis, push the FASTONs on the bottom
switch terminals as indicated in Figure 38. The black or white wire may be on
either side of the switch, so long as they both attach to the
bottom row
of contacts.
Figure 38-Installing power wires on the switch
10.
Leave the switch dangling outside the amp for now!!!
Install the RCA Jacks and Speaker Binding Posts
Locate the Left and Right channel shielded cable/ground harness assemblies. You will
now connect them to the Left and Right RCA jacks.
Figure 39-Installing RCA jacks
Left Channel RCA Jack Installation
The left channel RCA jack has a black ring. Install it from the outside of the chassis into
the left channel (marked) RCA jack hole. The mounting hardware arrangement is shown
in Figure 39. Use the left channel shielded cable and ground harness that you previously
built.
1.
Insert the RCA jack and the
two insulating washers
and ground lug as shown in
Figure 39. The ground lug already has two black wires attached. Tighten the
mounting nut. Note that there are shoulders on the insulating washer that keep the
RCA connector’s body from touching the chassis.
2.
Solder the (pre-tinned) red wire of the shielded cable to the center terminal of the
left channel RCA jack.
Right Channel RCA Jack Installation
The right channel RCA jack has a red ring. Install it from the outside of the chassis into
the right channel (marked) RCA jack hole. The mounting hardware arrangement is shown
