AKG SR 4000, Инструкция пользователя

Страница: 39 / 131

4 Operating Notes
4.3 Advanced Functions
4.3.1 NAME
• Entering a new name
• Saving or deleting a name
4.3.2 STATUS
The first screen is followed by the last.
3. To move from a setup screen to a submenu, press the SETUP control briefly.
The EXTRA screen (refer to section 4.2.2 above) provides the following submenus:
- NAME
- STATUS
- THRESH
- INFO
- EXIT
1. To call up the submenus in the above order, turn the SETUP control CW.
The last submenu is followed by the first.
2. To call up the submenus in reverse order, turn the SETUP control CCW.
The first submenu is followed by the last.
3. To call up the adjustment screen for the selected parameter, press the SETUP control briefly.
1. Select "NAME" from the EXTRA screen (refer to section 4.3 above). The first character will start flashing:
2. To change the first character turn the SETUP control CW or CCW.
3. Press the SETUP control briefly. The second character will start flashing.
4. Repeat the two steps above to change all characters as desired.
1. Press the SETUP control briefly. The display will change as follows:
2. To save your setting, press the SETUP control briefly. The display will revert to the Name screen.
•
If you'd rather not save your setting, turn the SETUP control CW. The display will change as follows:
• To delete the current name, turn the SETUP control CW again. This will display the following option:
3. Press the SETUP control briefly. The display will revert to the Name screen.
The "STATUS" submenu lets you activate a visual warning that alerts you to selectable critical system
conditions. If one of the selected conditions occurs, the LED ring around the SETUP control will change
from green to red and a warning message will appear on the display that describes the current condition.
The warning messages appear in the order of priority:
1. "LOW.BAT": Transmitter battery capacity is low.
2. "AFCLIP": Audio overload.
3. "RF.LOW": Received signal field strength is so low that the receiver audio output has been muted.
4. "DIV.ERR": Diversity function failed (less than ideal antenna position(s), cable(s)/antenna(s) defective).
The selected warning functions are basically active in LOCK and SETUP modes. In SETUP mode, how-
ever, the warning functions will be automatically deactivated while you make adjustments.
To delete the warning message from the display, press the SETUP control briefly. This will bring up the
next warning message or, if no other critical system conditions were detected, the normal screen. The
LED ring will revert to green.
1. Call up the EXTRA screen and select "STATUS". The display will change as follows:
38