Operation
40
DMM 4/2/4 Stereo
The rotary knobs on the front panel of the DMM 4/2/4 are operated as follows:
Figure 9: Operation of the rotary control
Turn the rotary control clockwise or counter-clockwise to make changes to inputs and outputs
and
function settings
function settings
function settings
function settings
(see "DSP functions" Page 41). These changes are shown on the LED
ring around the rotary control. The starting point and the increments on the LED ring will vary
according to function.
Audio level display:
NOTE
If the
LEVEL
LEVEL
LEVEL
LEVEL
(Page 41) function is selected, the set level is displayed on the LED rings of the
inputs and outputs.
Briefly
pressing the "SYSTEM CONTROL" rotary control switches the display on the LED rings
to VU meter, the display of the actual audio level present. As long as the VU meter mode is
activated, the LEVEL LED flashes on the "SYSTEM CONTROL" rotary control. Pressing the
"SYSTEM CONTROL" rotary control again deactivates the VU meter mode.
Control the properties of an input or output signal using the
Functions
Functions
Functions
Functions
(see "DSP functions"
Page 41) provided:
1)
Select the function you require using the "SYSTEM CONTROL" knob. Turn the knob until
the LED for the required function lights up.
2)
Control the input channels by means of the function selected using the rotary knobs.
3)
Control the output channel by means of the function selected using the "OUT MASTER"
rotary knob.
4)
Control the headphone stereo output channels using the "HEADPHONE" rotary knob.
The recording output has no adjustment options.
NOTE
The "SYSTEM CONTROL" knob returns to the "LEVEL" function ten seconds after the last
change.
DMM 4/2/4 operation
