General Specifications
0 dBu = 0.775 Vrms Output impedance of signal generator (Rs) = 150 Ω
All level knobs are nominal if not specified.
Frequency Response
Input to STEREO OUT
+0.5 dB/-0.5 dB (20 Hz to 20 kHz),
refer to the nominal output level @ 1 kHz, GAIN knob: Min
Total Harmonic Distortion
(THD+N)
Input to STEREO OUT
0.01 % @
+8 dBu
(20 Hz to 20 kHz), GAIN knob: Min
0.003 % @
+18 dBu
(1 kHz), GAIN knob: Min
Hum&Noise *1
(20 Hz to 20 kHz)
Equivalent Input Noise
-128 dBu (Mono Input Channel, Rs: 150Ω, GAIN knob: Max)
Residual Output Noise
-102 dBu (STEREO OUT, STEREO LEVEL knob: Min)
Crosstalk (1 kHz) *2
-88 dB
Input Channels
6 channels: Mono (MIC/LINE): 2, Stereo (LINE): 2
Ouput Channels
STEREO OUT: 2, PHONES: 1
Bus
STEREO: 1
Mono Input Channel Function
PAD
26 dB
HPF
80 Hz, 12 dB/oct
EQ HIGH
Gain: +15 dB/-15 dB, Frequency: 10 kHz shelving
EQ LOW
Gain: +15 dB/-15 dB, Frequency: 100 Hz shelving
PEAK LED
LED turns on when post EQ signal reaches 3 dB below clipping
(+11 dBu)
Level Meter
Post STEREO LEVEL
Knob
2 x 7-segment LED meter [PEAK (+11), +6, +3, 0, -3, -10, -20 dB]
Internal Digital Effect (MG06X)
SPX Algorithm
6 programs
Phantom Power Voltage
+48 V
Power Supply Adaptor
PA-130 (DC12 V/1.0 A, Cable length = 1.8 m), 120 V, 60 Hz, or
MU18 (DC12 V/1.5 A, Cable length = 1.5 m), 100 V-240 V, 50 Hz/60 Hz,
or an equivalent recommended by Yamaha
Power Consumption
12 W
Dimensions (W×H×D)
149 mm×62 mm×202 mm (5.9"x 2.4"x 7.9")
Net Weight
0.9 kg (2.0 lbs)
Optional Accessory
Mic Stand Adaptor: BMS-10A
Included Accessory
AC power adaptor, Owner’s Manual, Technical Specifications (this leaflet)
Operating Temperature
0 to +40°C
*1 Noise is measured with A-weighting filter. *2 Crosstalk is measured with 1 kHz band pass filter.
Analog Input Characteristics
Input Jacks
PAD
26 dB
GAIN
Trim
Actual
Load
Impedance
For Use
With
Nominal
Input level
Connector
Sensitivity *1
Nominal
Max. before
clip
MIC/LINE 1/L,2/R
OFF
+64 dB
3 kΩ
50-600 Ω
Mics/Lines
-72 dBu
(0.195 mV)
-60 dBu
(0.775 mV)
-46 dBu
(3.884 mV)
Combo jack*2
(Balanced)
+20 dB
-28 dBu
(30.85 mV)
-16 dBu
(122.8 mV)
-2 dBu
(615.6 mV)
ON
+38 dB
-46 dBu
(3.884 mV)
-34 dBu
(15.46 mV)
-20 dBu
(77.50 mV)
-6 dB
-2 dBu
(615.6 mV)
+10 dBu
(2.451 V)
+24 dBu
(12.28 V)
LINE 3/4, 5/6
-
-
10 kΩ
600 Ω Lines
-22 dBu
(61.56 mV)
-10 dBu
(245.1 mV)
+4 dBu
(1.228 V)
Phone jack*3
(Unbalanced)
Analog Output Characteristics
Output Jacks
Actual Source
Impedance
For Use With
Nominal
Output level
Connector
Nominal
Max. before clip
STEREO OUT L, R
75 Ω
10 kΩ Lines
+4 dBu
(1.228 V)
+18 dBu
(6.156 V)
XLR-3-32 *4
Phone jack *5
(Balanced)
PHONES
33 Ω
40 Ω Lines
2.4 mW + 2.4 mW
24 mW + 24 mW
Stereo phone jack
0dBu is referenced to 0.775Vrms.
*1 Sensitivity is the lowest level that will produce an output of +4 dBu (1.228 V) or the nominal output level when the unit is set to maximum gain. (All level knobs are at
their maximum position.)
*2 1&Sleeve = Ground, 2&Tip = Hot, 3&Ring = Cold
*3 Tip = Signal, Sleeve = Ground
*4 1 = Ground, 2 = Hot, 3 = Cold
*5 Tip = Hot, Ring = Cold, Sleeve = Ground
ZG97350
MIXING CONSOLE
Technical Specifications
See reverse side for block and level diagrams.
* Specifications and descriptions in this document are for information pur-
poses only. Yamaha Corp. reserves the right to change or modify products
or specifications at any time without prior notice. Since specifications,
equipment or options may not be the same in every locale, please check
with your Yamaha dealer.
Dimensions
The illustration shows the MG06X.
149
2
30
62
56
202
28
20
1
Unit: mm
