Important!
2.4 Unbalanced
Input
Fig. 4: Connecting
to an unbalanced
input.
Refer to fig. 4.
Note:
2.5 Optional
TM 40 Transmitter
Module
Start by removing
the XLR connec-
tor module:
Fig. 5: Removing
the XLR connector
module.
Refer to fig. 5.
Using any power supply other than those recommended
by AKG may damage your microphone and will void the
warranty.
You may connect AKG phantom power supplies to unbalanced
inputs, too.
Use a cable with a female XLR connector and TS jack plug:
1. On the XLR connector, use a wire bridge to connect pin 1 to
pin 3 and the cable shield.
2. Connect the inside wire of the cable to pin 2 on the XLR
connector and the tip contact of the jack plug.
Unbalanced cables may pick up interference from stray mag-
netic fields near power or lighting cables, electric motors, etc.
like an antenna. This may introduce hum or similar noise when
you use a cable that is longer than 16 feet (5 m).
The optional TM 40 transmitter module allows you to convert
your microphone into a wireless microphone that you can use
with any WMS 40 Series receiver from AKG.
1. Open the fixing screw (1).
2 Interfacing
15
C 5900
M
Phantom
1
2
