TRANSMITTER ON
Pull out the stop button and the transmitter is switched on. The
operation indicator lamp (STATUS) starts blinking and the
transmitter is on.
MAIN CONTACTOR ON
Then the transmitter is on press the
•
. This actuates the Main
Contactor in the receiver (the Main Contactor of the telpher) and the
telpher is ready for operation.
NORMAL RUN
The transmitter is designed with two pushbuttons for UP/DOWN
and two for FORWARD/BACKWARD. Each button is divided into
2 steps (a perceptible resistance) which facilitates the running at a
certain speed. The first speed is obtained when the pushbutton is
half compressed and the second speed is obtained when the
pushbutton is totally compressed.
All the motions can be run simultaneously and the motions stop
when the pushbutton is released,
otherwise make an
EMERGENCY STOP
.
MANUAL BC7400 No. 926137-000
Version: A0 Approved by: TB
Page 3 (8)
MICRO RUN
Push in the button for MICRO and the diode lamp for micro lights.
The micro-run movements are only at lowest speed in micro-run
mode irrespective of the compression of the pushbuttons. The
buttons are looped so that only one movement can be operated at a
time. The other functions are work as in ordinary runs.
PUSHBUTTON 1 AND 2
The diode lamps indicate which function who has been chosen.
The pushbutton function can be momentary (the function will be
active as long as the pushbutton is activated) or maintain (the
function is active when the diode lamp lights). See the installation
guide how to choose the function of the pushbuttons.
SIGNAL
A signal can be emitted at any time during the run and is obtained as
long as the push button switch is depressed.
EMERGENCY STOP
Depress the STOP button for Emergency STOP.
MANUAL BC7400 No. 926137-000
Version: A0 Approved by: TB
Page 4 (8)
FCC note:
The equipment user is required by the radio service rules to obtain a licence
before operating the equipment.