L-DCIM Upgrade Howto
- 5 -
Very Important Note:
If the unit’s power is lost during upgrade, the Normal Mode won’t start
anymore!
As a recovery feature, the unit should reboot back to Safe Mode and wait for either another attempt of
Firmware Update or
Factory Reset. If the automatic reboot to Safe Mode doesn’t work, you’ll need to
manually boot the unit to Safe Mode by pressing Reset button for about 8 seconds during startup, or
switch to Safe Mode boot by SSH commands (see below).
As the procedure completes, the 'Reboot to Normal Mode' button will be shown. Click to reboot.
Note:
on newer Safe Mode versions (180 and up) the unit will automatically reboot itself to Normal
mode after completing the firmware update, and you don’t need to press a button.
After this, the unit starts in Normal Mode again with the full APS-Server listening on the default
HTTPS port (443).
Normally the WebUI should automatically redirect and you don’t need to press the
‘Refresh’
button.
Please wait, sometimes the upgrade can take longer than a few minutes, do not remove power!
