01-05
06-10
FCC Requirement
This device complies with part 15 of the FCC Rules. Operation is subject to the following two conditions:
(1) this device may not cause harmful interference, and (2) this device must accept any interference
received, including interference that may cause undesired operation.
Note: This equipment has been tested and found to comply with the limits for a Class B digital device,
pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against
harmful interference in a residential installation. This equipment generates, uses, and can radiate radio
frequency energy, and if not installed and used in accordance with the instructions, may cause harmful
interference to radio communications. However, there is no guarantee that interference will not occur
in a particular installation. If this equipment does cause harmful interference to radio or television
reception, which can be determined by turning the equipment off and on, the user is encouraged to try
to correct the interference by one or more of the following measures:
– Reorient or relocate the receiving antenna.
– Increase the separation between the equipment and receiver.
– Connect the equipment into an outlet on a circuit different from that to which the
receiver is connected.
– Consult the dealer or an experienced radio/TV technician for help.
IC Caution
RSS-Gen Issue 4 December 2014"&"CNR-Gen 4e Décembre 2014:
- English:
This device complies with Industry Canada licence-exempt RSS standard(s).
Operation is subject to the following two conditions:
(1) This device may not cause interference, and
(2) This device must accept any interference, including interference that may cause undesired operation
of the device.
- French:
Le présentappareilestconforme aux CNR d'Industrie Canada applicables aux appareils radio exempts de
licence. L'exploitationestautorisée aux deux conditions suivantes:
(1) l'appareil ne doit pas produire de brouillage, et
(2) l'utilisateur de l'appareildoit accepter tout brouillageradioélectriquesubi, mêmesi le brouillageest
susceptible d'encompromettre le fonctionnement.
FCC ID : S5V-D0EKV2
IC
: 22901-D0EKV2
The device has been evaluated to meet general RF exposure requirement. The device can be
used in portable exposure condition without restriction.
FCC Caution:
• Any Changes or modifications not expressly approved by the party responsible for
compliance could void the user‘s authority to operate the equipment.
IC RF Exposure Information and Statement The SAR limit of Canada (C) is 1.6 W/kg
averaged over one gram of tissue. Device types: (
IC: 22901-D0EKV2
) has also been
tested against this SAR limit According to this standard, the highest SAR value
reported
during product certification for head use is
1.160
W / kg, The device was
tested for
typical bodily operations where the product was kept 5 mm from
the head. To maintain compliance with IC RF exposure requirements, use accessories
that maintain a separation distance of 0mm between the user's head and the back of
the headset. The use of belt clips, holsters and similar accessories shall not contain
metal parts in its assembly. Use of accessories that do not meet these requirements
may not comply with IC RF exposure requirements and should be avoided.
Head operation
The device was subjected to a typical head manipulation test. In order to comply with
RF exposure requirements, a minimum separation distance of 0 cm must be
maintained between the user's ear and the product (including the antenna). Head
exposure that do not meet these requirements may not meet RF exposure requirements
and should be avoided. Use only the supplied or approved antenna.
