Akai AA-V2080, Руководство оператора

Страница: 14 / 18

13
TEST TONE
It is to adjust playback level from different speakers and is only effective in Dolby Pro Logic and Dolby Digital
modes.
1.
Press
T.TONE
(Remote label 28) repeatedly to see L, R, LS, RS, C, and SUB sequentially.
2. Press the
VOL UP / DOWN
(Remote label 31 and 32) to adjust the sound level of each speaker.
3. The adjustable range is between –10dB and +10dB.
* You will hear some noise like sound when adjusting.
SPEAKER SETTING (SPK SETTING)
It is to select the speaker(s) to which the sound signal is sent out.
Press the
SPK SETTING
(Remote label 26) then
SPK ON / OFF
(Remote label 27) to get the followings:
Display Display
C
(it means the center speaker)
YES / NO
SL / SR
(it means the surround left and right speaker)
YES / NO
SPK SETTING
SUB
(it means the subwoofer)
SPK ON / OFF
YES / NO
* It cannot be adjusted under analog mode
DELAY TIME (Delay T.)
It is to adjust each speaker’s response time to output signal.
Press
SPK SETTING
(Remote label 26) then
DELAY T.
(Remote label 24 and 25). Then adjust by pressing the
DELAY T. UP / DOWN
(Remote label 24 and 25) repeatedly to get the followings:
Display Display Display
C CDL 0, 1, 2, 3, 4, 5
mS
SL / SR SDL 0, 5, 10, 15 mS
SPK SETTING
SUB
DELAY T.
VOL UP
/ DOWN
* It will have no response after pressing DELAY T. if that speaker is not connected.
BASS MANAGEMENT
It is to set the speaker bass.
1. Press
BASS MGT
(Remote label 12) to activate / off the bass of the speakers.
2. Choose from Mode 0, 1 or 2 for different bass combination.
Front L & R Center Surround L & R Subwoofer
Mode 0 Large large large On
Mode 1 Small small small On
Mode 2 Large small small On
* Small: speakers that cannot reproduce low sound of below 80 Hz with sufficient volume
Large: speakers that can fully reproduce low sound of below 80 Hz
* The small and large indication does not refer tot he physical size of the speakers, but according to the bass
reproduction capacity at 80 Hz.
* The default speaker setting is mode 1
DYNAMIC RANGE CONTROL (DYNAMIC)
It is to adjust the compression of the output sound level to protect you from hearing too loud sound / voice.
Large the compression, smaller the output sound level.
S
ETTING