Akai 29CT24FS, Руководство по обслуживанию

Страница: 10 / 56

SERVICE MANUAL
CIRCUIT ADJUSTMENTS
Preparation:
Circuit adjustments should be made only after completion of set-up adjustments.
Circuit adjustments can be performed using the adjustable components inside the TV set. For TVs
with I
2
C bus control, first change the bus data.
1. Degaussing
A degaussing coil is built inside the TV set. Each time the TV is powered on, the degaussing
coil will automatically degauss the TV. If the TV is magnetized by external strong magnetic field,
causing color spot on the screen, use a specific degausser to demagnetize the TV in the
following ways. Otherwise, color distortion will be shown on the screen.
1.1 Power on the TV set and operate it for at least 15 minutes.
1.2 Receive red full-field pattern.
1.3 Power on the specific degausser and face it to the TV screen.
1.4 Turn on the degausser. Slowly move it around the screen and slowly take it away from the TV.
1.5 Repeat the above steps until the TV is degaussed completely.
2. Confirmation and Adjustment for Voltage
Caution: +B voltage has close relation to high voltage. To prevent X-ray radiation, set +B
voltage to the rated value.
2.1 Power on the TV and receive Philips test pattern.
2.2 Check the resistors and coils for being burned. (If the fuse is burned out, do not power on the
TV again until the cause is found out.)
2.3 ---Measure voltages of test points with the digital voltmeter. Measure the CRT high voltage with
the high-voltage testing equipment and heater voltage with the high-frequency effective
voltmeter. The rated values are shown as below.
Table 2
Test Point Voltage (V) Test Point Voltage (V)
Negative of VD871
82V ± 5V in standby
134
±
1.5V in use
Positive of C414 5
±
0.5V
Positive of C879 5 ± 0.5V Positive of C412 9 ± 0.5V
Positive of C882 9
±
0.5V Negative of VD872 16
±
1V
Positive of C117 32
±
1V Negative of VD873 16
±
1V
Negative of VD402A 12.5 ± 1V Negative of VD874 16 ± 1V
Negative of VD404 27
±
1.5V Negative of VD403 190
±
5.0V
Heater 6.3+0.2\-0.3Vrms CRT anode 29.5
±
1.2KV
3. High Voltage Inspection
Caution: No high voltage adjustment components inside the chassis. Please perform
high voltage inspection in the following ways.
3.1 Connect a precise static high voltmeter to the second anode (inside the high voltage cap) of the
CRT.
3.2 Plug in the supply socket (150-250V, AC) and turn on the TV. Set the brightness and contrast
8